INSYS Modem 336 LL 2D/4D 5.x Originate / Answer
AT Command Reference
Command Description
AT*L<n>
Determines the automatic speed limitation
The automatic speed limitation is used to automatically achieve the least possible error
rate for connections without error correction.
In the factory settings, the speed limitation is always switched on (
AT*L0
).
If the limitation is switched off (
AT*L1
), the INSYS Modem 336 LL 2D/4D 5.x Originate /
Answer will always establish the connection on the phone side with the maximum
possible speed (or the speed defined with
AT+MS
), irrespective of the data rate at the
serial interface. This means that the INSYS Modem 336 will, for example, always at-
tempt to establish a 33600 baud connection, even if the serial interface is only set to
9600 baud. Without error correction the high speed will obviously lead to higher bit
error rates, which is usually disruptive.
The automatic speed limitation (
AT*L0
) will limit the speed on the phone side to the
speed of the serial interface.
It should only be switched off if very low baud rates are employed or if the speed of the
serial interface is changed during the connection.
ATM<n>
Speaker control
This command regulates when the speaker is active
(see command
ATL<n>
).
ATM0
Speaker
always
OFF
ATM1
Speaker ON during dialing and connection setup (default)
ATM2
Speaker
always
ON
ATM3
Speaker ON during connection setup
AT+MR=<n>
Show modulation type
The command
AT+MR=<n>
enables the display of the modulation type after the mes-
sage
CONNECT
.
AT+MR=0
Switches the data flow control OFF (default)
AT+MR=1
Switches the display function ON. The displayed value applies to the
sent data.
AT+MR=2
Switches the display function ON. The displayed value applies to the
received data.
If the display function is switched on the INSYS Modem 336 LL 2D/4D 5.x Originate /
Answer will display the modulation type and the line speed after the message
CON-
NECT
. After the message
CONNECT
the line "
+MCR:
" appears, followed by the modula-
tion type (see command
AT+MS
and the line "
+MRR:
", followed by the line speed.
Note:
The command
AT+MR
is useful for a connection check.
57
Summary of Contents for Modem 336 LL 2D/4D 5.x Originate / Answer
Page 1: ...Manual INSYS Modem 336 LL 2D 4D 5 x Originate Answer INSYS Modem 336 Leased Line Apr 10...
Page 2: ......
Page 80: ......
