INSYS Modem 336 LL 2D/4D 5.x Originate / Answer, Manual

Page: 65 / 80

INSYS Modem 336 LL 2D/4D 5.x Originate / Answer AT Command Reference
Command Description
AT*X Terminate remote configuration
The command AT*X terminates a remote configuration.
AT&Y<n>
Selection of user configuration for hardware reset
AT&Y0
For a hardware reset following the
AT&Y0
command, the user default 0
(created using the AT&W0 command) is loaded into the current modem
configuration.
AT&Y1
For a hardware reset following the
AT&Y1
command, the user default 1
(created using the AT&W1 command) is loaded into the current modem
configuration.
AT*Yx,y Switch outputs
x : Port (OUT1=0, OUT2=1)
If no port is specified (x), OUT1 is used
y : Desired condition of the output (relay open =0, relay closed =1)
Default:
AT*Y0,0 AT*Y1,0
ATZ<n> Software reset
The command causes the INSYS Modem 336 LL 2D/4D 5.x Originate / Answer to per-
form a software reset. The INSYS Modem 336 LL 2D/4D 5.x Originate / Answer will load
the default saved by the user (according to the parameter). If no parameter is specified,
the user default 0 is loaded.
ATZ0
Software reset; afterwards the user default 0 is loaded.
ATZ1
Software reset; afterwards the user default 1 is loaded.
<Pause> +++
<Pause>
Change from data mode to command mode (online command mode).
1 second pause before and after the entry, no Return - <CR> -. After the response OK , an
additional waiting period of 1 second for the re-entering of AT commands must be
observed.
<Pause>
****
<Pause>
Start of the remote configuration at the local modem
After the 4 escape characters
****
were entered at the local modem (1 second pause
before and after the entry, no return - <CR> -), the remote configuration at the remote
terminal is activated. After the response
OK
, an additional waiting period of 2 seconds
for the re-entering of AT commands must be observed.
65