Functions
INSYS Pocket ISDN
36
10.4
Remote Configuration
You can configure the INSYS Pocket ISDN with another ISDN TA from remote. You
can configure a password, authorised callers as well as a remote configuration
number to restrict access. The configuration is performed via the TA+Configurator.
This is automatically started after the connection establishment for remote
configuration.
The remote configuration is active as default. No password is entered and all callers
are authorised.
10.4.1
Remotely Configuring the INSYS Pocket ISDN
The following describes the commands for the remote configuration of an
INSYS Pocket ISDN using a second INSYS Pocket ISDN:
Your terminal program is connected to the local INSYS Pocket ISDN.
1.
Configure the B channel protocol X.75 at the local INSYS Pocket ISDN
using the command
ATB10.
2.
Establish an ISDN connection to the "Remote TA" using the AT
dialling command. Use the command
ATD<phonenumber>e.
The extension "e" at the end of the phone number establishes an
internal control connection to the remote TA
The "Remote TA" replies with a password request.
password:
3.
Enter the correct password.
If the INSYS Pocket ISDN has been reset to factory settings: enter no
password, just press Enter.
Each line starts with a "#" character during remote configuration. Use
the TA+Configurator commands (refer to table TA+Configurator
commands).
In order to read out the settings for example, use the command
showall
.
4.
Configure the INSYS Pocket ISDN, which is to be remotely
configured, now.
5.
Save the settings (if desired) with the command
save
.
6.
Exit the remote configuration with the command
go
.
