INSYS Pocket ISDN
Functions
33
10.2.2
Disabling an Automatic Call
If the function "automatic call" is enabled, the INSYS Pocket ISDN does not accept
AT commands anymore. To be able to configure the INSYS Pocket ISDN again, you
must disable the function.
To change the INSYS Pocket ISDN to configuration mode with enabled function
"automatic call"
The function "automatic call" is active.
Your terminal program is connected to the INSYS Pocket ISDN.
The speed of the serial interface is configured to 9600 bps.
1.
Perform a reset of the INSYS Pocket ISDN.
2.
The terminal program displays the message
"+++ press <CR>, <CR>, <ESC>,<ESC> to enter TA+Configurator
+++".
This message does not appear if it is disabled using the command
AT**RSTMSG=0
.
3.
Quickly double-press the "Enter" key and the "ESC" key.
You are in the TA+Configurator and can configure the INSYS Pocket
ISDN with the dedicated TA+Configurator commands again.
4.
Enter
cmds=0
to disable the "automatic call" function.
5.
Save the settings (if desired) with the command
save.
6.
Exit the remote configuration with the command
go
.
