INSYS Pocket ISDN
Initial Operation
25
1.
Start your PC, which is connected to the INSYS Pocket ISDN.
The INSYS Pocket ISDN is detected by the operating system and the
hardware installation wizard starts.
2.
Follow the instructions of the installation wizard.
If the installation wizard is not able to locate the required drivers,
unpack the driver, which is located on the CD in the driver section,
and install it manually. Please note that the drivers for the INSYS
Pocket ISDN Internet and Profi are different.
The INSYS Pocket ISDN driver for Windows XP is installed now.
Testing the INSYS Pocket ISDN
The INSYS Pocket ISDN is connected to the PC.
The power supply of the INSYS Pocket ISDN is present.
A terminal program, e.g. Teraterm, is installed on the PC.
1.
Open your terminal program.
2.
Open the serial interface, to which the INSYS Pocket ISDN is
connected.
3.
Enter
AT
into your terminal program.
The response will be
OK
.
If you don't receive the response OK, check the connection and if the
INSYS Pocket ISDN receives power. Repeat the test.
The R/T LEDs are illuminated as long as you are entering.
If the R/T LEDs at INSYS Pocket ISDN do not illuminate as long as you
enter
AT
and receive an
OK
, it might be that you are connected to a
different modem (e.g. with the internal modem of the laptop or PC).
In this case, check to which interface your INSYS Pocket ISDN is
actually connected and repeat the test.
The INSYS Pocket ISDN is installed successfully and ready for
configuration.
