Insportline Rapid SE, Owner'S Manual

Page: 53 / 58

52
Tool:
4. Handlebar, Computer, and Foot Pedal Installation
Remove two M8x15 Bolts (22) and Ø16xØ8 Curve Washers (27) from the Handlebar Post
(8). Insert the Hand Pulse Sensor Wires (2) into the hole on the Handlebar Post (8) and
then pull them out from the top end of the Handlebar Post (8). Attach the Handlebar (5)
onto the Handlebar Post (8) with two M8x15 Bolts (22) and Ø16xØ8 Curve Washers (27)
that were removed. Remove four M5x10 Bolts (6) from the Computer (7). Connect the
Hand Pulse Sensor Wires (2) and Middle Section Sensor Wire (17) to the wires that come
from the Computer (7). Tuck wires into the Handlebar Post (8). Attach the Computer (7)
onto the top end of the Handlebar Post (8) with four M5x10 Bolts (6) that were removed.
The Cranks, Foot Pedals, Pedal Shafts and Pedal Straps are marked “R” for Right and
“L” for Left.
Insert the pedal shaft of Left Foot Pedal (21) into threaded hole in the left Crank (38).
Turn the pedal shaft by hand in the counter-clockwise direction until snug.
Note: DO NOT turn the pedal shaft in the clockwise direction, doing so will strip the
threads.
Tighten the pedal shaft of Left Foot Pedal (21) with the Multi Hex Tool with Phillips
Screwdriver provided.
Insert pedal shaft of Right Foot Pedal (40) into threaded hole in right Crank (38).
Turn the pedal shaft by hand in the clockwise direction until snug.
Tighten pedal shaft of Right Foot Pedal (40) with the Multi Hex Tool with Phillips Screwdriver
provided.
Multi Hex Tool with Phillips
Screwdriver S13, S14, S15
Allen Wrench 6mm
40
38
21
38
8
27
22
7
17
2
2
6
5