Sealing your shower
You will now need to apply a final sealing of panels built and joints
made to ensure integrity while in use. We recommend vercal and
horizontal joints be sealed very neatly, also the three piece joint
made earlier, file rough edge if you have one and fill joint. Front
angled glass, seal lip. In addion we always seal glass to frame us-
ing a very small nozzle in sealing gun. Not always crical but we
find worth doing for peace of mind. If you do this be very careful
not to get silicone over the glass as it can be hard to remove. If you
have done so, wait unl dry to remove.
For the latest fing instrucons please visit
www.insigniarange.co.uk
What Should I Know About Steam Room Safety?
Please visit the following link:
hp://www.insigniarange.co.uk/instrucons/
Steam_Safety_Please_Read.pdf
Whirlpool bath operaon.
Two chrome knobs are found at the top of the bath behind head-
rest. The one nearest the black nted glass operates the whirlpool
pump On / Off. The other one allows air to bleed into the system.
Turning this increases or decreases this funcon. Please note using
air in the water system for a long period will drop the temperature
of the bath water more rapidly
Connecng Shower to Water Mains.
The water inlet of the shower valve has two inlets. These are
marked blue and red. There are two variaons of the valve As be-
low:
A)
or B)
(A) Connect the water feed from you house Cold to Blue. Red to
Hot. The bo8om connecon goes to “Water In” of steam generator
(B) Connect water feed from House Hot to Red. On Blue side a8ach
“Tee” juncon. Now connect one end to the Steam Generator
“Water In” and the other direct to House supply Cold.
For the latest fing instrucons please visit
www.insigniarange.co.uk
31 32
Important!
Never use the steam
generator with the vent
holes poin ng towards
the shower wall or a
person.
Never use the steam
outlet in the closed posi-
on. This excessive heat
will damage your tub
and this is NOT covered
under your warranty
terms.
