For the latest fing instrucons please visit
www.insigniarange.co.uk
Now taking the upright in picture screw the angled bracket to it.
The upright varies both ends. You need the end that is shaped to
lip over the bath tub. The top surface is flat.
For the latest fing instrucons please visit
www.insigniarange.co.uk
Now take the three angled
frame parts and assemble as
picture below.
2 x angle brackets placed
together.
1
2
3
1.
Align with edge of
frame on bend of
brackets
2.
With pilot hole drilled
remove brackets and
drill through both and
drill through frame
just marking the
brackets
3.
Repeat opposite end.
Screw each part to-
gether inside
Got a small gap in
joint? A Li8le Loose?
This is of no concern as
it will be sealed with
sealer later in build.
With this item screwed together tape on the outside, secure the
upright column to the back glass frame panel by same means as
before 4 x screws drilling first. Taking the second column repeat
securing the same way on the opposite corner (black back panel)
Rest in place the bo8om curved
secon that will eventually join to
the angled part assembled earlier. It
should now look as the picture be-
If yours is like this please pro-
ceed!
15 16
Please skip this secon for the 8058/9
as this has already been pre installed
for you.