ED. 2010/11
4.Reception and Installation
9
Figure 4.4
INOXPA is not liable for the improper unpacking of the control head and its components.
Proceed with due care. Failure to do so may result in personal injuries.
The assembly and stripping of the control head must only be carried out by qualified personnel.
4.5.
FITTING THE HEAD
4.5.1.
Fitting
7
1
Position the
detector shaft in
the upper part of
the pneumatic
actuator, carefully
screwing it until it
is well secured.
Use:
•
a conventional
17mm spanner
for
C
-
TOP
with
proximity
detectors
•
a conventional
7 mm spanner
for
C
-
TOP
with
microswitches
2
Then position the
C
-
TOP
in the
upper part of the
actuator, paying
special attention
to the base seal.
3
Screw down the
two screws that
will secure the
C
-
TOP
to the
actuator.
Before putting the valve into operation, check to make sure that the head is tightly secured to the
valve and that there are no loose parts.
Only a cross-point screwdriver is needed to fit the head.
