Console Line Interface
Port Configuration
200R205-000
Innovx FastSwitch 24 Ethernet Switch
5-5
Issue 3
Installation and Operation Manual
Port Configuration
Display Port Configuration
show port command displays interface information such as speed, duplex mode and connector type.
User can choose to display the configuration of an individual port by typing the port number (e.g.,
0.12) or choose to display the configuration of all the ports of the switch by typing the keyword "all"
after the show port command.
LS2W> show port <slot.port/all>
LS2W> show port all
The first column in the display,
Slot.Port
, indicates the type of physical/logical port and the
associated port number. The following are the possible slot options values:
•
0 - Physical port on the front of the switch (10/100Mbs FE ports in L2SW switch
•
1 - Physical port on the front of the switch (1Gbps GE ports) in L2SW.
The second column indicates port Type. If the port is a FE port, this field is displayed as 100Tx. If
the port Gigabit it is displayed as 1000Tx.
The third column displays the administrative mode for the port. Depending on the state of the port,
one of the following values will be displayed:
•
Yes - Admin mode enable
•
No - Admin mode disable
The fourth column displays the Physical Mode, which is either Manual or Auto. In Auto mode,
Speed is set by auto-negotiation process.
The fifth column indicates Physical Status - Indicates the port speed and duplex mode. Note that the
values displayed indicate the capabilities negotiated with the peer and not necessarily the
capabilities of the switch itself:
•
1000 Full - 1000 Base-T
•
1000 Base-SX/LX, Full duplex
The sixth column indicates the actual speed of the connected network element.
The seventh column indicates the Link Status - Indicates whether the link is up or down.
The eighth column indicates whether the Flow control is on or off
The ninth and tenth column indicates the Rate Control settings for ingress and egress side of each
port.
The eleventh column indicates the port priority status. Values displayed under this column are High
or Low or Off (Disabled)
The twelfth column indicates the security status of the port. On indicates security is enabled and off
indicates security is disabled.
Note
By default, admin and auto negotiation modes are enabled on all ports.
Summary of Contents for FastSwitch 24
Page 121: ......