16
Copyright © 2008 Innovatech Products & Equipment Co., Inc. All Rights Reserved.
Shutting Down the Terminator 2100XM
1.) Release the drive control levers.
2.) Lower the blade to the floor.
3.) Turn the ignition switch counter-clockwise to the OFF position.
4.) Turn the propane tank control off turning the valve clockwise.
5.) Inspect the machine for damage.
6.) For safety, remove propane tank and key.
Taking Up Floor Coverings
1.) Insert the blade. (Refer to Blade Assembly below.)
2.) Lower the blade to the floor. As the blade flexes lift caster wheel off the floor ¼ inch. Drive
forward.
3.) As the Terminator 2100XM is removing flooring material have another person at the side of the
machine, remove all debris.
Blade Assembly
Blades are available in different configurations and thickness. An assortment of blades is included in the
purchase price of the Terminator 2100XM. Extra blades are available upon request from Innovatech
Products & Equipment Co., Inc.
1.) Raise the blade assembly to the maximum up position, which is four inches off the floor.
2.) Unwrap the pre-sharpened blades and select the blade thickness and length you need for the job.
3.) Loosen the seven holding bolts.
4.) Insert the sharpened blade with the beveled side up.
5.) Tighten bolts firmly, starting from the center and working out. Bolts should be snug but not over
tightened.
