INNOVATECH PRODUCTS & EQUIPMENT CO, INC. .
Copyright © 2008 Innovatech Products & Equipment Co., Inc. All Rights Reserved.
9
Safety Features
The Terminator 2100XM is equipped with several features to help ensure your safety and the safety of
any personnel in the work area.
Warning Light and Back up Alarm:
An amber light is installed on the top rear section of the hood.
When the Terminator 2100XM ignition is in the ON position, the warning light will flash. The back up
alarm sounds when the drive control is set in
REVERSE
to provide a warning signal that the machine is
moving in reverse.
Fire Extinguisher:
A fire extinguisher is located on the hood behind the operator’s seat. Regularly
inspect the gauge and recharge the fire extinguisher as needed to maintain full capacity. Always
recharge the extinguisher after each use.
Auto Stop:
The Terminator 2100XM has two drive levers located to the left and right of the operator’s
seat and a blade height switch located directly in front of the operator’s seat. The drive levers control the
forward, reverse, left, and right directions of the machine. The blade height switch raises and lowers the
blade. You must push (forward) or pull (reverse) and hold the levers in position to drive the machine in
the direction desired. When a lever is released, the Terminator 2100XM automatically STOPS. The
machine will not move again until you push/pull and hold the levers.
CAUTION:
Do not use the levers as a parking brake. Block wheels with a floor block when stopping on a
ramp or incline. The machine will roll on any sloping surface without a floor block.
Safety Warnings
FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
ALWAYS WEAR EYE PROTECTION
. Wear eye protection to provide protection against flying particles
from the front and side of the machine. All personnel in the work area, including the operator, must
always wear eye protection when loading, operating, and servicing the machine.
ALWAYS WEAR EAR PROTECTION.
Wear ear protection to protect the ears from exposure to high
noise levels. All personnel in the work area, including the operator, must always wear ear protection
when loading, operating, and servicing the machine.
ALWAYS WEAR A HARD HAT.
Wear head protection to protect the head from flying debris. All
personnel in the work area, including the operator, must always wear a hardhat when operating the
machine.
ALWAYS PROVIDE PROPER VENTILATION.
Ventilation is required when using the Terminator
2100XM. Positive or negative pressure ventilators must be used in any enclosed space where the
machine is to be used. Use Carbon Monoxide (CO) monitoring when the machine is used in doors. The
Carbon Monoxide generated by propane engines can be hazardous to your health if proper ventilation is
not provided.
Use caution while loading, operating, and running the Terminator 2100XM.
•
Do not operate the Terminator 2100XM unless you have been provided instruction on the safe
operation of the equipment.
•
NEVER operate the Terminator 2100XM unless every guard, warning notice, or sign is in place.
•
DO NOT operate the Terminator 2100XM while under the influence of drugs, alcohol, or medication.
•
DO NOT operate the Terminator 2100XM near an open flame or smoking materials.
•
DO NOT run the machine onto piles of debris.
•
NEVER operate the Terminator 2100XM in any manner that may cause the machines to become
unstable and tip over.
•
NEVER engage in horseplay on or near the Terminator 2100XM.
