6
Copyright © 2008 Innovatech Products & Equipment Co., Inc. All Rights Reserved.
Introduction
The Terminator® 2100XM Carpet and Tile Removal Machine is intended for use on demolition projects,
asbestos abatement projects, and smaller floor covering removal jobs. Designed and built by
experienced floor covering demolition and installation experts, the machine incorporates several design
features that are essential for efficient operation:
Tricycle wheelbase and short turning radius
allows for better maneuvering and turning ability
– especially in narrow spaces.
Blade vertical and tilt position adjustments
allow for positioning the blade to the appropriate
angle for the each application to improve efficiency.
Ballast in front and rear
provides extra traction needed for tile and glue removal.
Built-in forklift transport slots
allows for easy loading and unloading at job sites.
Propane powered engine
provides high fuel efficiency and low air pollution. Propane does
however produce carbon monoxide and other gases, which may be harmful to your health if not
used in well-ventilated areas. See the Ventilation Requirements.
Catalytic Converter
provides high fuel economy and lowers emission of harmful gasses.
If operated and cared for as instructed in this Manual, the Terminator 2100XM provides trouble-free, safe,
and efficient performance.
About this Manual
Read this Manual before you operate or service the equipment.
This manual contains the information
and procedures to assist you to operate and maintain the Terminator® 2100XM safely and correctly. If
you need additional information or assistance, please get in touch with our Customer Service
Department:
Innovatech Products & Equipment Co.
832 80th St SW
Everett, WA 98203 USA
(425) 402-1881 or 800-267-6682
Fax (425) 402-8547
Email: [email protected]
NOTE:
Throughout this Manual directional instructions (left, right, up, down, push, pull, etc.) are given
from the point of view of the operator performing the action.
Tools and Supplies
The following tools and supplies are required for proper equipment maintenance and should be available
at the job site.
1.) 4” or 7” Grinder
2.) WD 40
3.) 10”-15” Crescent Wrench
4.) ¾ Open End and Box Wrench
5.) 16-20 oz. Hammer
6.) Screw Driver Set
7.) Socket Set 1/4 – 3/4, 3/8 set or 1/2
8.) Safety Glasses
9.) Grease Gun
10.) Ear Plugs