INNOVATECH PRODUCTS & EQUIPMENT CO, INC. .
Copyright © 2008 Innovatech Products & Equipment Co., Inc. All Rights Reserved.
19
Maintenance
1) Grease the caster wheel at three fittings every 30 hours. There are three fittings, two on the
wheel and one on the housing.
2) Remove debris caught between the wheel and the housing. Clean out wheel and housing
regularly.
3) Change the engine oil every 3 months or 50 hours with SAE 30. Check the engine owner’s
manual for oil recommendations for temperatures below 32
°
F.
4) Change the oil filter – (available from Innovatech).
5) Check hydraulic oil once a week. Change every 18 months with NUTO H 46 or ISO 46 or if fluid
is overheated 160
°
F – 180
°
F or higher, filter every 60 hours.
6) Clean the caster wheel and rear tires using a wire wheel as necessary.
7) Change the air cleaner when dirty (available from Innovatech).
8) Change spark plugs, rotor, and distributor cap every 12 months or 200 hours. Refer to the Honda
Engine GX620 Owner’s Manual for the correct gap and part numbers.
9) Inspect the machine for leaks, find and tighten fittings – do not over tighten fittings.
10) Check all hoses and clamps once a week.
11) Inspect rear tires and lug bolts. Tighten lug bolts as needed to 70-foot pounds torque.
12) Check wheel hub every 60 hours of operation. Wheel hub should be tightened from 310 to 350-
foot pounds (ft.-lbs).
Safety Equipment Inspection and Maintenance
Verify that the following equipment is proper working condition before operating the T-2100XM.
•
Fire
extinguisher
•
Backup light and siren
•
Parking
brake