Innova IGPCX-27-1, Owner'S Manual

Page: 14 / 76

ENG
12
Using the buttons on the remote control
5
button
6
button
7
HEALTH | SAVE button
8
X-FAN button
When this button is pressed in cooling or drying mode, the remote control displays
“X-FAN” and the X-FAN function is started. Press this button again to cancel the X-FAN
function. “X-FAN” will disappear from the display.
9
TEMP button
Press this button to see the set temperature.
10
TIMER button
●
In ON status, pressing this button once will set TIMER OFF. “HOUR” and “OFF” will flash in the
display. Press the “+” or “-” button within 5 seconds to adjust the time for TIMER ON. Each time
the “+” or “-” button is pressed, the time will increase or decrease by half an hour. Press and
hold the “+” or “-” button, and after 2 seconds the time will change quickly until you reach your
required time. After that, press the “TIMER” button to confirm it. The HOUR and OFF symbols
will not flash again. Cancel TIMER OFF: Press the “TIMER” button again in TIMER OFF status.
●
In OFF status, pressing this button once will set TIMER ON. Please refer to TIMER OFF for de-
tailed operation. Cancel TIMER ON: Press the “TIMER” button again in TIMER ON status.
Note:
• When the X-FAN function is activated, when the unit is turned off, the fan will continue to
operate for a while at low speed to dry the residual water inside the unit.
• When the unit is operating in X-FAN mode, pressing the “X-FAN” button will turn off the
X-FAN function. The fan stops operating immediately.
*
Not available for this model
Note:
• Time setting range: 0.5–24 hours.
• The time interval between two operations cannot exceed 5 seconds.
Otherwise, the remote control will exit the setting status automatically.