12
Version 1.03 January-2002
1. Enter the User Editing Mode.
Press
,
,
.
2. Enter the User number to be changed.
Press
, then the User number
(User 2 to User 47), then
The User number will be displayed on the Terminal via the Zone Lamps.
NOTE: If the User number is greater than 16, the first digit will be displayed via a flashing Zone
Lamp. If you need to check the User number, press
to view the second digit.
3. Enrol the User’s Access Card. (If required)
Present the Card at any Access Reader in the system within 30 seconds of selecting the User
number.
Three short beeps will sound to confirm that the Card has been enrolled and assigned to the
selected User.
If the Card is already assigned to another User, or is not recognised by the system, one long beep
will sound to indicate a problem.
4. Enter the new PIN Code.
Press
, then the new PIN number
... (4 or 6 digits), then
Three short beeps will sound to confirm the PIN number has been programmed.
If the PIN is rejected, one long beep will sound to indicate a problem.
5. Assign the User Type.
Press
Press
, then the new User Type number
, then
USER TYPE: 0 Arm only
Can only Arm the system.
1 Arm/Dis-arm
Can Arm and Dis-arm the system.
2 Arm/Dis-arm/Isolate Can Arm/Dis-arm the system and Isolate Zones.
3 Master
Can perform all operations above & Master User Operations.
2 beeps will sound to confirm the new User Type has been programmed.
4.1 ADDING / CHANGING / DELETING USERS.
NEXT 20
ADDING OR CHANGING A USER