Configuration manual
Configuration
9
Selection of one of the cabinets from the control panel layout (
[E]
) will show it both on the left (
[A]
), where the installed
IFM modules with their addresses and firmware revision are shown, and on the right (
[F]
), where the installed FPM
external modules are shown. From this section you can access the configuration phase of each module by tapping on
the icon which represents it.
2.4
Addressing IFM and FPM modules
In order for the control panel to identify each module individually, it is
necessary to assign an address to each one. It is possible to assign the same
address to modules of different types, however, modules of the same type
must have different addresses.
To assign an address to a module, it is necessary to tap on the module
shown in the section it belongs to (internal IFM modules on the left
[A]
; FPM
front-plate modules on the right
[F]
).
A window will open (
[H]
), select the desired address in the programming
field, then tap on
Set
.
Note:
Addresses which exceed the maximum number of modules supported by the control panel will not be
considered valid.
Following is a table containing the addresses allowed for each type:
[A]
Internal layout of the
selected cabinet
[B]
Internal module
detected
[C]
Position empty
[D]
Address and firmware
revision of detected
module
[E]
Map of the entire
control panel
[F]
Layout of the selected
cabinet
[G]
Buttons to carry out
setting changes or to
exit without saving
FPM Module
Maximu
m
number
Address
IFM Module
Maximu
m
number
Address
fro
m
to
fro
m
to
FPMLED
7
1
7
IFM24160
4
1
4
FPMLEDPRN
1
/
IFM2L
8
1
8
FPMEXT
5
1
5
IFM4R
16
1
16
IFM4IO
16
1
16
IFMDIAL
1
/
IFM16IO
4
1
4
IFMNET
1
/
IFMLAN
1
/
IFMEXT
24
1
24
N.01 FW:1.0.0.
N.02 FW:1.0.0.
N.12 FW:1.0.0.
Set
Esc
Access level:3
01/01/2020
18:23
B
A
C
D
E
F
G
C
C
C
C
B
B
D
D
Module xxx
Address
12
Esc
Set
H
