English
English
Instructions for assembly
Please be very careful when removing the lamp from the packaging,
so as not to damage the paper shade.
Remove the cable ties and unwind the cables completely.
Important:
Do not connect the lamp to the power supply until
the assembly is completed.
u
Operation
Tilt the lamp and pull out the telescope rod to adjust the height.
Fasten the rod with the Allen key.
③
Slide the two protective sleeves on the wire supporting the paper
shade.
④
Connect lamp cable to plug-in transformer.
⑤
To switch the lamp ON or OFF, press the dimmer switch. Keep
the switch pressed down longer for dimming.
⑥
The dimming stops when the highest or lowest possible brightness
is reached. For further dimming, release the button and then press it
again. Please do not hold the button down continuously (> 20sec.).
u
Cleaning
Important:
Never use damp cloths, sponges or similar on the
paper shade! Clean the shade if necessary with a light feather
duster or paintbrush. The metal parts can be wiped with a dry
cloth.
8
u
Technical specification
100-240 Volt 50-60Hz. Secondary 18 V DC, 500mA, 0,6 cos
ᵩ
The lamp has a wide-range input power supply for operation with
100-240 Volt.
LED 9 W, 970 lm, 2700 K, CRI>90, dimmable.
The lamp is supplied with built-in LEDs of energy class A
+
.
According to the manufacturer, the LED has an average life of
25 000 hours. It cannot be replaced by the user.
A defective lamp, ballast or LED module must be dis-
posed as electronic scrap and must not get into dome-
stic waste.
Any repairs that may become necessary must be carried out
by a qualified electrician.The legal and contractual warranty for
defects and product liability will be void, should the installation
instructions not be duly followed or non-original components be
employed.
9
