41
Operation without control panel
The unit can be operated without control panel.
In that event, only remove the control panel
after complete installation.
2.8.2
Mounting and connecting the control panel
1. Lay the control cable. 2. (20 AWG)
2. Slide the control panel out of the wall holder.
3. Connect the control cable to terminal X397.
Caution:
Ensure that the wall behind the wall holder
is even.
Caution:
Place the control panel in the housing
supplied if class IP54 is required. The
openings for the cable guide must be on the
bottom.
4. Screw the wall holder onto the junction box or
on to the wall.
Caution:
The control panel should only be put back
into the wall holder when the power supply
of all the connected units has been
switched on.
2.8.3
Connecting the control panel to the unit
Warning:
Make sure that the power supply on
which you are working has been turned
off.
For water-heated models type WH (-2) and
models without heating
1. Insert the control cable into unit
Feed the cable in through either end of the
row of units, as you choose.
Fasten the cable to the edge inside the unit,
using the cable clips.
Warning:
Do not allow the cable to lie or hang
loose.
c
c
c
w
w
1
Summary of Contents for SchwankAir 3500 Series
Page 108: ...108 ...
