April 10, 2013
INFODRAW TMRS User Manual v5.3
155
1)
You can now unplug the USB cable from the PC and the device.
2)
Turn the TMRS device off.
3)
Change back the left 2 dip switches (numbers 1,2 to down position).
4)
Insert the SIM card into the TMRS unit.
5)
Ensure the GSM/GPS Antennas are connected to the unit.
Once you activate the TMRS unit, the Input sensors will be at TTL
“Active high”
or
“Active
Low”
as defined in the Device Configurator.
In order to trigger an
Input
signal you need to close a connection between the following
wires on the “GPIO/PTZ Cable”:
Port 1) Input 1 wire
and
GND wire.
Port 2) Input 2 wire
and
GND wire.
Port 3) Input 3 wire
and
GND wire.
Port 4) Input 4 wire
and
GND wire.
Once an Input Sensor is triggered, the
“Sensor
number
” signal on the left hand side will light
up. The preset trigger actions will also commence accordingly. If you selected recording as a
trigger action, the message/s
“M”
“D”
will appear at the top right hand side of the video
stream.
The statuses of the Input signals are
viewed in the TMRS Device tree on the
left hand side under
“Sensors”
.
Sensor 1
= Alarm Button
Sensor 2
= Input 1
Sensor 3
= Input 2
Sensor 4
= Input 3
Sensor 5
= Input 4
