Measuring Current Consumption in Different Power Modes
www.cypress.com
Document No. 002-14914 Rev. *C
7
2.
Set the HCI Control Transport profile.
a.
On the
Transport
menu, click
HCI Control
.
b.
In HCI Control Window Transport:
■
Select
UART
.
■
In the top
UART
list, type the COM port of the PC to which the DUT is connected (
com4
).
■
In the bottom
UART
list, select
115200
.
■
Select the
CTS flow control
check box, and then click
OK
.
Reset the DUT
1.
While in HCI Control: com4@115200, press the
3 key
on the keyboard to select the Host controller & baseband
commands.
2.
In the list of Host Controller & Baseband commands, double-click
Reset
. In Log Window, verify that the DUT
has been reset.
Set the Sleepmode parameters
1.
In HCI Control: com4@115200, press the
0 key
on the keyboard to select the Vendor-specific commands.
2.
In the list of Vendor-specific commands, double-click
Set_Sleepmode_Param
.
3.
In HCI Command: Set_Sleepmode_Param (com4@15200):
a.
Make the following settings:
■
Sleep_Mode
UART
■
Idle_Threshold_Host
0x0
■
Idle_Threshold_HC
0x0
■
BT_WAKE_Active_Mode
Active High
■
Host_WAKE_Active_Mode
Active High
■
Select the following check boxes:
■
Allow_Host_Sleep_During_SCO
■
Combine_Sleep_Mode_And LPM
■
Enable_Tristate_Control_Of_UART_Tx_Line
■
Pulsed_HOST_WAKE