IndigoVision 9000 Series, User Manual

Page: 32 / 68

32 User Guide - v7
Run the cabling to the access point
When the wall or ceiling has been prepared, run the required cables up to the cable access
hole.
Fit the Camera Assembly
1. Connect the cables to the camera as required.
2. Secure the camera to the surface using appropriate screws such as No.6 x 1inch
(3.5mm thread by 25mm) stainless steel screws with the appropriate head.
Setting up the sensor
When you are setting up the sensor, you can view analog video output on a video monitor.
This can be accessed by connecting the supplied analog video cable to the 2-way flying
connector within the camera.
Sensor
Assembly
Locking
Screw
T/W
N/∞
Default Top
of image
Figure 24: Camera lens assembly
Ensure the camera lens assembly does not obstruct the fan as this may reduce the
effectiveness of the fan, and impair image quality in low light conditions.
1. Remove the three security screws fixing the Bezel (1) to the Camera Assembly (6).
2. Remove the Bezel, the Dome Bubble (2) and the Lens Shroud (3).
3. Remove the safety label attached to the lens.
The sensor assembly may be hot. Hold the lens when positioning the camera lens assembly.
4. Release the locking screw and rotate the Lens Assembly (5) to the required position.
Secure the locking screw when done to fix the tilt and lens orientation.
Take care not to over-rotate the camera lens assembly as this may result in the internal
cables becoming disconnected.
5. Focus the lens.
► For more information, see "Focus Procedure" on page 40
6. Re-fit the Dome Bubble and Lens Shroud.
4 Installation Enhanced SD Fixed Dome - 9000 Range