User Guide - v7
33
Ensure the 2-way analog connector is tucked it under the cover to prevent it from obscuring
the field of view of the camera.
7. Re-fit the Bezel to secure the Dome Bubble to the Camera Assembly. To ensure a
watertight seal, tighten the screws to a minimum of 15 Nm (11 lbs/ft) and maximum of
20 Nm (15 lbs/ft).
Focus Procedure
The camera is supplied with a varifocal DC auto iris lens.
The iris must be set to maximum aperture when setting the focus. Use Electronic Shutter
mode to force the iris to maximum aperture.
An analog video cable with a 2-way connector is provided with the camera to help during
camera installation.
1. Set
Exposure
mode of camera to
Electronic Shutter
using the Configuration pages.
►
For more information, see "Configuration" on page 43
2. Adjust the angle of view. Loosen the T/W adjustment thumbscrew, then rotate the T/W
adjustment accordingly.
Tighten the thumbscrews when you are done.
3. Adjust the focus. Loosen the N/∞ adjustment thumbscrew, then rotate the N/∞
adjustment accordingly.
Tighten the thumbscrews when you are done.
4. Revert the
Exposure
mode of camera to
Auto Iris
using the Configuration pages.
►
For information about using a 9-22mm lens, see "Using a 9-22mm lens" on page 41
With Exit Collar
Once you have configured your camera's IP settings, you are ready to install it in its final
position.
There are four stages to installing the Standard Vandal Resistant variant with the exit collar:
1. Run the cabling to the access point
2. Fit the exit collar to the wall/ceiling
3. Fit the camera to the exit collar
4. Set up the sensor
Run the cabling to the access point
When the wall or ceiling has been prepared, run the required cables up to the cable access
hole.
Fit the Exit Collar
The Exit Collar has cable exit holes on the side and top. Before fitting the Exit Collar, ensure
the exit holes which are not being used are sealed using the blanking plug or grommets
provided.
Enhanced SD Fixed Dome - 9000 Range
4 Installation
Summary of Contents for 9000 Series
