IndigoVision 9000 Series, User Manual

Page: 21 / 68

User Guide - v7 21
When using an exit collar, use a 5-10mm diameter cable with a round section.
A 24V DC, 500mA PSU with mains power lead can be ordered from IndigoVision, the base
order code is 110004. Add -1 to the base order code for a UK IEC mains lead, -2 for a US IEC
mains lead and -3 for an EU IEC mains lead.
Initial camera configuration
You must configure your camera’s IP settings before you mount it in its final position.
You can configure your camera using the Web Configuration pages or the console port.
Initial IP properties
The following table displays the initial, default IP properties for a device.
Table 4: Initial IP properties
Initial Configuration
IP Address 10.5.1.10
Subnet Mask 255.0.0.0
Default Gateway 10.0.0.1
Using the configuration pages
To configure your device using the Configuration pages you must do the following:
1. Prepare an isolated network.
2. Prepare your PC for initial device configuration.
3. Configure your device. This includes specifying its IP address and subnet mask.
You must also have one of the following:
• A CAT5 crossover cable suitable for connection between the PC and the RJ45
connector on the device
• A power source
• 24V PSU
• PoE switch with two standard CAT5 cables
• PoE injector/midspan with one standard CAT5 cable and one CAT5 crossover
cable
Preparing an isolated network
Connect your device and the PC you are using to configure it on their own isolated network.
To do this, connect the device to the PC using an Ethernet cross-over cable.
Enhanced SD Fixed Dome - 9000 Range 3 Getting Started