IndigoVision 9000 Series, User Manual

Page: 20 / 68

20 User Guide - v7
Ensure you remove the packing material from inside the camera before operating the camera.
First remove the camera bezel by unscrewing the three security screws situated around the
dome bubble (use the Torx T10 bit supplied). Lift off the bezel, the dome bubble, and the lens
shroud.
Powering up the 9000 SD Fixed Dome
The camera is a Power Over Ethernet (PoE) powered device compliant with the IEEE802.3af
standard.
There are a number of methods of powering up the camera:
• Power over Ethernet (PoE) switch
• PoE injector/midspan
• Auxiliary power
The camera dissipates 6W maximum power, excluding the heater power.
When operating in temperatures below 0°C (32°F), the Environmental Vandal Resistant
variant requires a 12V DC auxiliary power supply to operate the heaters.
Using a Power over Ethernet switch
To power up the camera using a Power over Ethernet (PoE) compliant switch, attach the
CAT5 cable for the camera to a PoE switch.
Using a Power over Ethernet injector/midspan
If a Power over Ethernet (PoE) switch is not available, the camera can be powered using a
PoE injector/midspan, such as Phihong POE36U-1AT.
Fixed
Dome
Cat5 cable
Network switch
PoE Midspan
Mains
Power
In
Out
Figure 13: Using a PoE injector/midspan
Auxiliary power
The camera can be powered using the auxiliary power input on pins 1 and 2 of the 18-way I/O
connector on the rear of the camera.
► See "Connections" on page 12 for details about the pin numbering scheme of the I/O
connector.
Auxiliary power requirements are 24V AC or 24V DC at 250mA (6VA max).
Use 18AWG (or 1mm
2
) cable to connect an auxiliary power supply to the camera.
The auxiliary power input to the camera is not polarity sensitive, therefore, a DC power
supply can be connected in either polarity.
3 Getting Started Enhanced SD Fixed Dome - 9000 Range