Indian Motorcycle Indian Challenger 2020, Owner'S Manual

Page: 61 / 178

ITEM INSPECTION PROCEDURE
Brake
Components Inspect hoses and connections.
Throttle Inspect hand grip and throttle movement.
Clutch Check lever operation and freeplay.
Front
Suspension
Check for leaks, debris and damage.
Steering Check for smooth operation by turning handlebars full
left and full right.
Rear
Suspension Inspect for leaks.
Ride Height Make sure preload is adjusted properly for load.
Rear Drive
Belt Check for wear or damage. Check drive belt tension. See
page 105.
Sidestand Verify smooth operation, inspect pivot bolt and spring.
Fasteners Inspect for loose, damaged or missing fasteners.
Mirrors Adjust for proper rear view.
Trunk/
Saddlebags If equipped, make sure the trunk and saddlebags are
properly installed and that lids are securely closed.
EENNGGIINNEE OOIILL LLEEVVEELL
With the semi-dry sump lubrication system, the engine oil level on
the dipstick will fluctuate, depending on the motorcycle’s position
and engine temperature when checked. To ensure a proper
reading of the engine oil level, follow all inspection procedures
closely.
WARNING
Operating with insufficient, deteriorated or contaminated engine
oil will cause accelerated wear and may result in engine or
transmission seizure, which could result in loss of control and
serious injury or death. Check the oil level frequently.
Always check the oil after running a cold engine at idle for 30
seconds. The oil fill/dipstick is located on the left side of the
motorcycle. Always use the recommended oil. See page 155.
1. Position the motorcycle on level ground in the fully upright and
centered position.
2. Start the engine (from cold) and allow it to idle for 30 seconds.
Stop the engine.
59
PRE-RIDE INSPECTIONS