Indian Motorcycle Indian Challenger 2020, Owner'S Manual

Page: 142 / 178

4. Enter a new 4-digit security PIN of your own choosing. If the PIN
is successfully entered, the security light and/or power switch
will remain on and the horn will sound briefly. Proceed to step
5.
TIP
If the 4-digit PIN is NOT successfully entered within 20 seconds,
the security light and/or power switch will flash for 10 seconds,
then the system exits the procedure. Return to step 1 to try again.
5. Re-enter the new 4-digit PIN. If this entry matches the first entry,
the security light and/or power switch will turn off and the horn
will sound briefly. The new rider PIN has been saved.
Record
your new rider PIN on page 7.
TIP
If the second entry is not entered within 20 seconds or does not
match the first entry, the security light and/or power switch will
flash for 10 seconds, then the system exits the procedure. The
new PIN was NOT saved. Continue to use your former valid PIN.
Return to step 1 to try again.
EENNGGIINNEE CCOOM MPPRREESSSSIIOONN TTEESSTT
An engine compression test can be performed to monitor general
engine condition. See the
INDIAN MOTORCYCLE Service Manual or
an authorized INDIAN MOTORCYCLE dealer can assist.
EEXXHHAAUUSSTT SSYYSSTTEEM M IINNSSPPEECCTTIIOONN
Check the exhaust system for stains from leaking exhaust gasses.
Replace damaged or leaking exhaust gaskets. Check all exhaust
system fasteners. Tighten loose clamps and fasteners. Do not
overtighten. See the
INDIAN MOTORCYCLE Service Manual or an
authorized INDIAN MOTORCYCLE dealer can assist.
EELLEEVVAATTIINNGG TTHHEE M MOOTTOORRCCYYCCLLEE
WARNING
Serious injury or death can occur if the motorcycle tips or falls.
Make sure the motorcycle will not tip or fall while elevated or
while on the sidestand.
Some procedures require raising the motorcycle to remove weight
from the component being inspected. Elevate the motorcycle by
placing a stable, flat platform jack or lift mechanism on a firm, flat
surface and lifting under the engine crankcase. The platform
should be a minimum of 12 inches (30 cm) square. DO NOT
attempt to lift the motorcycle without proper equipment. Always
secure the motorcycle properly before lifting so it cannot tip or fall
when elevated.
RROOAADD TTEESSTT
Before returning the motorcycle to regular use, perform a road test
in a safe area. Pay special attention to the proper fit and operation
of all serviced components.
Make any corrections or additional adjustments promptly to
ensure safe, reliable and enjoyable vehicle performance.
140
MAINTENANCE