Indian Motorcycle Indian Challenger 2020, Owner'S Manual

Page: 150 / 178

CCLLEEAANN AANNDD PPRROOTTEECCTT TTHHEE M MOOTTOORRCCYYCCLLEE
To prepare the motorcycle for storage, begin by cleaning and
polishing the motorcycle as outlined beginning on page 145.
Polish chromed and other metal surfaces. Apply protectant to
exposed rubber, vinyl and plastic parts.
Do not apply rubber
protectant to the tire tread surfaces.
FFUUEELL SSTTAABBIILLIIZZEERR
Add fresh fuel to fill the fuel tank and add fuel stabilizer. Do not
overfill.
Ride the motorcycle or start and run the engine for 15 minutes in a
well ventilated area to distribute the stabilizer throughout the fuel
system.
TTIIRREE IINNFFLLAATTIIOONN
Inflate the tires to normal pressure. See page 125.
EENNGGIINNEE PPRROOTTEECCTTIIOONN
Change the engine oil.
BBAATTTTEERRYY CCAARREE
1. Remove the battery. See .
2. Clean the battery terminals first with a wire brush to remove
any loose deposits.
3. Wash the posts and the ends of the battery cables with a
solution of one part baking soda to 16 parts water. Rinse with
clean water and wipe dry.
4. Apply a thin film of dielectric grease to the posts and cable
connectors.
5. Clean the outside of the battery with a solution of mild
detergent and warm water.
6. Store the battery in a dry area with a temperature of 32° to 90° F
(0° to 32° C).
7. While in storage, fully charge the battery once a month. See .
M MAAIINNTTEENNAANNCCEE DDUURRIINNGG SSTTOORRAAGGEE
During extended storage periods, maintain tire pressure and
battery voltage at the recommended levels.
RROODDEENNTTSS
Mice and other rodents are often the worst enemy of a stored
motorcycle. If the motorcycle will be stored in an area where mice
are a concern (particularly in rural areas, barns, sheds, etc.) be
sure to take extra measures to deter their infestation. This may
include placing a screen mesh over any intake or exhaust
openings (remember to remove them when you remove the
motorcycle from storage).
148
CLEANING AND STORAGE