Indian Motorcycle Indian Challenger 2020, Owner'S Manual

Page: 107 / 178

AADDDDIINNGG CCOOOOLLAANNTT
To add coolant, do the following:
1. Remove the seat and rubber lid.
2. Remove he overflow bottle cap
e
to add coolant. Add coolant
until level is within the marked values.
NOTE
The rubber and formed nylon can be left connected while
performing this procedure.
CAUTION
Do not fill the coolant bottle to full. 0.3 L of air must remain in the
bottle to account for thermal expansion. Failure to do so can
result in coolant overflow.
RREEAARR DDRRIIVVEE BBEELLTT CCLLEEAANNIINNGG
TIP
Do not inspect or adjust drive belt tension when the belt or drive
system is wet or hot. Improper adjustment will result.
Cleaning the drive belt will maximize belt and sprocket life and
minimize drive line noise. Clean the belt at every tire change.
Clean the belt more often if riding in dirty, dusty or high debris
environments.
1. Mix a few drops of mild dish soap with a cup of warm water.
2. Use a soft nylon brush to clean the belt and sprocket teeth with
the soapy water. Clean well in corner areas where road debris
and belt dust can collect.
3. Rinse the belt with clear water, then dry thoroughly.
105
MAINTENANCE