Restore Factory Defaults
"Restore Factory Defaults" is a special barcode. The BCST-10
Barcode Scanner will respond with a short beep (high tone) after
reading this barcode. At this time, the scanner system could restore
factory defaults, and no need to read "Exit with Save" barcode
again. The Scanner defaults enable HID, PIN defaults 10010.
Note:
Most of setting mode have restore factory defaults selection.
The factory default value for each setting is indicated by an asterisk
"*".
You could use this barcode at the following status:
1. The scanner can not work. For example, it can not read barcodes.
2. You forget the settings you did to the scanner before, and you
don't want to be affected by the settings when you use the
scanner.
3. After using a function which is not be used usually in the scanner.
Check Software Version
If you want to know the software version of BCST-10, should read
the ‘Enter Setup’ and ‘Output Software Version’ barcode:
Checking the software version is done at the enter setup mode, so
after output the software version, need to read ‘Exit without Save’
barcode.
Restore Factory
Enter Setup
Output Software Version
Exit without Save
10
Summary of Contents for BCST-10
