26
Using Your Transceiver as a Shutter Release
Option 2: Two-Click Continuous Shooting
1. With all devices turned off, connect and secure the transceiver to the camera by plugging
the camera dedicated shutter release cable into the Camera remote [
] port and the
other 3.5mm end into the transceiver’s output [
]. (Attach the Transceiver to the
camera by using the lanyard or a cold shoe bracket)
2. Turn on your camera and set it to continuous shooting mode. Make sure to set your
shutter speed to any other than Bulb.
3. Turn on the transceiver and set it to Transmitter/Receiver (Tx/Rx) mode using the M
button. Next, activate the transceiver’s Bulb mode by holding down the Bulb Mode
button. The LCD display will flash a B to indicate when the function has been activated.
4. On the transceiver, half press the Shutter Release button to auto-focus the camera.
5. Fully press the Shutter Release button to activate the camera’s shutter. A timer will
appear on the LCD panel displaying the time elapsed.
6. Press the button again to stop continuous shooting.
7. Push Bulb button twice to turn off “B” mode.
