17
Wireless Remote Triggering with Studio Strobe
1. With all of the devices turned off, connect and secure the receiving (on-strobe)
transceiver to the studio strobe. Among other ways, this can be done using the included
lanyard strap or supplied adhesive-backed hot-shoe mount. The backing of the mount
can be trimmed as necessary.
2. Connect the studio strobe to the on-strobe transceiver using the appropriate cable to the
3.5 mm output sync [
] port.
3. Turn on the camera, studio flash, and transceiver units.
4. Set the on-camera transceiver to Transmitter (Tx) or Transmitter/Receiver (Tx/Rx) mode
using the M button.
5. Set the on-strobe transceiver to Receiver (Rx) or Transmitter/Receiver (Tx/Rx) mode
using the M button.
6. Select and match the channel and group settings on the transceivers.
7. Trigger the studio strobe by pushing the on-camera shutter release button or the on-
camera transceiver’s Test button
If your studio light has a 1/4” phono jack, you will need to use the included 3.5mm to 1/4”
phono adapter. Additional sync cables are available separately.
