20
Using Your Transceiver as a Shutter Release
The PowerSync 16-80 transceiver can be used to trigger your camera. The
wired shutter
release functionality of the PowerSync 16-80 only requires the use of one transceiver
device. The
wireless functionality of the PowerSync 16-80 requires you to have two units
(one transmitting transceiver, one receiving transceiver) to operate.
Camera compatibility and camera specific remote shutter release cables are available
separately. See included flyer for camera and shutter release cable
compatibility list.
Using the Transceiver as a Wireless Shutter Release
Single Shot:
1. With all devices turned off, connect and secure the receiving (on-camera) transceiver
to the camera by plugging the camera dedicated shutter release cable into the Camera
remote [
] port and the other 3.5mm end into the transceiver’s output port [
].
2. Turn on the on-camera transceiver and set it to Receiver (Rx) mode using the M button.
3. Turn on the transmitting (in-hand) transceiver and set it to Transmitter (Tx) mode using
the M button.
4. Synchronize the group and channel selection on both devices.
5. Turn on your camera and set your camera to single-shot mode.