AFFIX THE BASE TO THE DESK TOP
Now that the base is correctly aligned with the table top,
join the two by using the 12 provided screws (Part # 12).
It is a good idea to use a screwdriver or drill bit with a
magnetic tip as it will help in the alignment of screw to
recessed nut. Secure tightly.
STEP 8
For narrow frame models (42”, 47” and 59”), connect the
frame and desk at 12 points with the 12 screws provided
(Part # 12).
For wide frame models ( 71” and 83”), connect the frame
and desk at 14 points with the 14 screws provided (Part
# 12). The 2 extra screws are used to connect the metal
sleeve through the extension channel to the underside of
the desk.
INSTALL POWER SUPPLY
6
STEP 9
Plug in the left side and the right side leg control cables (Part # 15c) into each
of the 6-pin motor sockets.
Plug the hand controller (Part # 15b) into the socket next to the 6-pin sockets.
Place the control box (Part # 15a) between the two crossbars and line up the
two holes on the control box with the pre-drilled holes on the underside of
the desk. Attach with the provided screws (Part # 16b)
Connect the power supply using the
provided 3 prong cable (Part # 15d)
to a 3 prong outlet.
Only do this
after all the other connections have
been established and the desk is
upright – in the desired location.
(15d)
POWER SUPPLY
(15b) HAND
CONTROLLER
(15c) 6-PIN PLUGS
(15c) 6-PIN PLUGS
(15a) CONTROL BOX
