4
ASSEMBLY INSTRUCTIONS
TABLE TOP BASICS
The Olympus Select top is 1-1/8” and comes with pre-drilled
recessed nuts on the underside.
Be sure to clear your working area of any materials that might
scratch or damage the top of the desk. Lay the table top on the
floor upside-down on carpet or a blanket.
OPEN THE BOXES OF THE BASE PARTS.
Remove the base parts from their two boxes and arrange the contents near your assembly area. Check to make sure you have all the
necessary parts.
ATTACH THE FEET TO THE LEGS
Using the provided Allen key, attach the feet to each leg using 4 hex
socket cap screws (Part # 4) for each leg. Secure tightly so there is no
wobble.
Use your hand to screw the
levelling pads (Part # 1) into the
openings at either end of each
foot (Part # 2). These pads help
to level the desk in the event
of an uneven floor surface and
can easily be adjusted once
assembly is complete. For now,
hand turn them all the way in.
ATTACH TOP SUPPORT ARMS &
CROSSBAR TO THE LEGS
Attach the crossbars (Parts # 5 & 6) to both
sides of each motor housing using 8 hex-
socket cap screws (Part # 4). Take care to align
the holes accurately so that the screws go
in straight. Make sure the top edge of each
crossbar is aligned with the top edge of the
motor housing. Tighten securely.
Attach the Top Support Arms (Part #7) to the
base such that the side with four large holes
(two at either end of the arm) faces down to
the floor and the side with two small holes
is flush with the motor housing. Use 4 hex-
socket cap screws (Part #4), 2 per arm.
Note - The crossbars are marked A and B. Each
leg requires an A and B crossbar. See photo 1.
Front
Back
A
A
B
B
1
Crossbar Positioning
STEP 2
STEP 3
STEP 4
STEP 5
2
3
4
Attaching the crossbars – photo 1,2 & 3.
Attaching the top support arms – photo 4.
