i
Quick Start Guide
Always read the full instruction manual before using
iDrive
.
This quick start guide is to assist in installing and running the
iDrive
to verify that the
iDrive
and motor are working properly. Starting, stopping and speed control will be from the
keypad. If your application requires external control or special system programming, consult
the
iDrive
EDX instruction manual supplied with your inverter.
Step 1 - Before applying power to your
iDrive
Please refer to Chapter One (Preface) and Chapter Two (Safety Precautions) of the
iDrive
EDX instruction manual. Verify drive is installed in accordance with the procedures as
described in Chapter Three (Environment and installation). If something is suspected of being
abnormal, do not apply power to the drive until qualified personnel have corrected the
situation. (Failure to do so could result in death or serious injury.)
•
Check inverter and motor nameplates to determine that they have the same power and
voltage ratings. Ensure that full load motor current does not exceed that of the inverter.
•
With power OFF, remove the terminal covers to expose the motor and power terminals.
a. Verify that AC power is wired to L1(L), L2, and L3(N) .
b. Verify that motor leads are connected to T1, T2, and T3 .
c. If a brake module is necessary, please connect terminal voltage of the braking unit to P
and N of the inverter. Never connect a resistor directly to
iDrive
terminals P and N.
iDrive
EDX keypad
Step 2 - Apply power to your
iDrive
Apply AC power to the drive and observe the keypad display. The 7-segment LED display
should show power voltage (ie 220) for 3~5 seconds and then show the Frequency Command
(Hz), factory set at 5.00. (Frequency Command shown on 7-segment display should be
flashing, ie inverter output OFF.)
Quick Start Guide
7-SEGMENT
LED
DISPLAY
FREQUENCY
SETTING
POTENTIOMETER
POWER ON
LED
