76
destination address. Additionally, the original program is also routed to a second IP
Output on Ethernet 1.
MPTS Splitting: ASI In (3ch ATSC)
→
IP Out
: This template demonstrates MPTS
Splitting (i.e., converting MPTS to SPTS) from ASI Input 1 to IP Outputs on Ethernet 1.
Programs 3, 4 and 5 on ASI Input 1 (which is the typical usage for ATSC feeds) are
routed.
MPTS Splitting: IP In (2ch ATSC)
→
IP Out
: This template demonstrates MPTS
Splitting from an IP Input to an IP Output. It creates an IP Input with a multicast address
on Ethernet 1, and routes programs 3 and 4 (typical of ATSC feeds) to IP Outputs on
Ethernet 1 with multicast addresses.
Clear Current Configuration Button
The
Clear Current Configuration
button clears all the configured ports and streams as follows:
All ASI Ports are disabled.
All IP Inputs are deleted.
All IP Outputs are deleted.
All Connections are removed.
All Transcoders are reset to their default configuration and disabled.
The Test Packet Generator is disabled.
The button does not affect the following areas:
The settings in the
Network
tab are not changed.
The settings in the
Admin General
tab are not changed.
Saved configurations are not modified in any way.
Dashboard™ will take a few seconds to reload (longer if you are accessing over a wide-area
network), but the actual configuration in the MVN-XC440 is virtually instantaneous. The Status
Message Area will indicate the result of the operation.
Admin Test Packet Generator Tab
The MVN-XC440 includes two Test Packet Generators (TPGs), capable of generating a
configurable constant bit rate sequence of MPEG-2 Transport Packets with very strict timing.
The TPGs are considered a source (input), and are available to be connected to any output. The
user interface for the TPGs includes a current status table, which reports the current
configuration of the generators.