60
Transcoder Apply/Cancel Buttons
When the
Apply
button is clicked, the following actions take place:
The transcoder configuration takes effect.
Any connections selected for removal in the Established Connections are deleted.
Any new transcoder input/output connections are added.
If there are no errors, the transcoder configuration area closes. If any errors are detected, the
configuration area remains open and an error message is displayed by the
Apply
button. The
possible error messages are:
Error: no available transcode licenses
: there are no more licensed transcoder sessions
available (check the Admin License Keys Tab). Contact ImmediaTV if you need to
acquire additional licenses.
If the
Cancel
button is clicked, all changes are discarded and the transcoder configuration area
closes.
Transcoder Statistics Tab
This tab provides a summary status of all the transcoding sessions. A sample is depicted below.
The possible indicator status values are:
OK
: The transcoder session is operating normally (it has a valid input and is
transcoding that input).
Waiting for Input:
The transcoder session is configured and enabled, but it has no
input. This can be because it has no connection to an input port, or because the port has
no programs, or because the selected program is not available in the connected port.
Dashboard Card State will be yellow unless there is a higher-priority alarm active.
No Output:
The transcoder is not generating an output stream. This can happen if the
input stream is corrupted, encrypted, or has an unsupported compression type. This
status may also be briefly displayed when the transcoder is starting. Check the input to
see if it is decodable. Contact ImmediaTV Customer Support if you get this status with a
clean decodable stream. Dashboard Card State and the Status LED will be red.
Status Unknown:
The control system is unable to manage the transcoder session.
Contact ImmediaTV Customer Support if you get this status. Dashboard Card State and
the Status LED will be red.