65
o
Auto-Select:
This option is useful when the transport is not yet present, and the
program numbers are unknown. If this option is selected, the MVN-XC440 will
select the first program found in the transport. When operating in an SPTS
environment, it is sufficient to use this option for all connections. The actual
program number can be found in The Current Connections Table once the route is
established.
o
Enter Program Number:
If the transport is not yet present, but a specific
program number to be connected is known a priori, this option can be selected.
However, please note that no data will be transferred if this program is not present
in the transport. If this option is selected, a new field will appear:
Any valid program number can be entered in the
Program Number
field.
Destination Selection
The Destination Selection operates in the same fashion as the Source Selection. It is again a
three-step process, where a port is selected, then a stream on that port is selected, and finally a
desired output program number is selected.
The Destination Port Selection is depicted below. The options are as follows:
Ethernet 1:
UDP/IP Output streams transmitted on Ethernet Port 1.
Ethernet 2:
UDP/IP Output streams transmitted on Ethernet Port 2.
Transcoder:
Programs to be transcoded.
ASI Output:
Streams for one of the two ASI Outputs.
Note that the list may not include all the possible ports – it depends on the Source Selection.
Some Source-Destination combinations are not allowed by the MVN-XC440 (for example,
Ethernet to ASI Output).
Once the port is selected, the
Destination Stream
drop down menu is populated with the
available output streams on that port: