25
Network Tab
The Network Tab allows for configuration/monitoring of the two Ethernet ports.
Network Configuration Tab
The Network Configuration Tab is used to set the individual parameters for each of the Ethernet
ports.
The following parameters can be configured:
Alarm on Link Loss:
If set to Yes, the card will raise an alarm if this Ethernet interface
loses link. The Card State indicator in Dashboard™ and the front Status LED will both
be red. If set to No, the card will still report loss of link in the Statistics page but no
alarm will be raised. ImmediaTV recommends turning on the alarm for ports that are in
use; only turn it off if you do not plan to connect that port to a network.
IP Address:
Enter the desired IP address for this Ethernet port. Please note that the
MVN-XC440 uses a block of 4 IP addresses for internal communication; these addresses
cannot be used for the external network interfaces. The reserved addresses are:
o
10.253.254.252
o
10.253.254.253
o
10.253.254.254
o
10.253.254.255
Please contact ImmediaTV Corporation if this is an issue for your network.
Subnet Mask:
Enter the desired subnet mask for this Ethernet port.
Default Gateway:
Enter the desired default gateway for this Ethernet port, or 0.0.0.0 if
no gateway is available.
Interface Settings:
If you make any changes to the IP Address, Subnet Mask and/or
Default Gateway fields, the
Apply
and
Cancel
buttons become active. The changes only
take effect when you press the
Apply
button. Pressing the
Cancel
button reverts the