IMET Spa VELOX 350 AF-NC, User Instructions

Page: 37 / 73

Page
VELOX 350 +SIRIO 370AF-NC FAST INSTRUCTIONS 10
•
•
•
70.0% = is the percentile position of the start of
the cut , that is the start cutting position: normally is
about 8/10 mm over the piece surface. Also this can
be changed by numbers
•
in this picture we changed it in 75.
•
•
At the end of this personalization you move down
the little line, and if the program is as you want ,
push F6 button [ Ok ] to memorize it.
•
•
Now push F2 [ list of program] , choice for it by
the red arrows and push RUN button -at the right
upper corner- to select it . The display shows again
the program,
•
•
you push the start button [ I ] at the left side ,
then you are asked for the trim cut [F1] or not [ F2 ].
•
Making the choice the machine runs.
•
Block the end bar sensor in the position of present
bar to avoid a cycle stop.
•
The machine carries out the program right until
the end. If it stops because there is no more
material 'bar end', after reloading the bar it is
necessary to re-start the automatic cycle which
will take up from the point at which it stop.