IMET Spa VELOX 350 AF-NC, User Instructions

Page: 32 / 73

Page
VELOX 350 +SIRIO 370AF-NC FAST INSTRUCTIONS 8
-15.2- PREPARATION FOR THE SEMIAUTOMATIC CYCLE (one cut)
Put the work piece you have to cut in the vice, close manually the jaws and open them of an half turn, by leaving 3/4 mm
between the piece and the jaws necessary for a better using of automatic closing, and place it a little back from the cutting
line. A magnetic sensor is placed on the left machine vice, to allow cicle starting only if material is clamped. The right side
vice is not controlled, use it to clamp pieces after blade line.
By indexed clamping lever you can slide the vice left/right -
Be sure that the handle . 11/RI0165- blocks the rotation of the work table.
The support of the feeder forward jaw - pos. 5/dr. RIO347 - has a limited stroke, but it can be moved from one slot to
another one to reach the maximum opening; lock the two hexagon socket head cap screws after each position changing.
Also the plate with rollers –pos. 3/RI0347- can be adjusted in order to piece dimensions.
Firmly lock the handle - pos. 1/dr. RIO322 - in order to stop the rotation of the worktable.
Turn the general switch on, reset the emergency button if it has been pushed, close the feeder cover, push AIR button –
as indicated , to restore air into the plant, close the vice by pushing proper buttons and then check the effective closure of
the jaws (and of the vertical vice, if used) on the workpiece.
R otate on 1 the cutting speed regulator - pos. 2 /dr. RIO503- and push the white button [ I ] to START CYCLE -Whatever
the cycle may be stated, the machine makes the following :
Rapid approach ( with the blade in motion) to the work piece , slow down feed of cutting , blade stop , rapid return
The setting of the most suitable cycle, supply of the coolant, and so on has to be done according to the
requirements of the work that must be achieved.