IMET Spa VELOX 350 AF-NC, User Instructions

Page: 72 / 73

Page
VELOX 350AF-NC ED.2008 rev.00 9/73
•
-New control panel –MAHLER- for circular sawing machines SIRIO 370 AF-NC- VELOX 350 AF-NC
•
This panel shows some buttons that are not in use on these machine, and others that can cause misunderstanding about their function. Here are resumed:
•
1= ARROWS < > ^ v = TO CHOOSE DIRECTIONS, PAGE, OR HELP SCROLL
•
2 =RUN = START THE PROPER PROGRAM
•
3= PGM = EDIT THE STEP OF THE PROGRAM
•
4= DIR = DIRECTLY CAN SCROL FROM ALL PROGRAMS
•
5= from F1 to F6 = PUSH THEM AS THE PICTURE THAT IS SHOWS ABOVE
•
6= DISPLAY =AT THE BOTTOM APPAIRS SOME ICONS , TO SELECT THEM USE F1 to F6 BUTTONS
•
7= LIGHT = DISPLAY LIGHT ADJUSTMENT
•
8= I = START THE WORKING CICLE OR THE ZERO-SETTING DURING CALIBRATION
•
9= O = STOP CICLE
•
10 to 14 not used
•
15= AIR SUPPLY = PUSH IT FOR AIR INTO PLANT ;PUSH AGAIN TO OUT OF PLANT
•
16=COOLANT SUPPLY = PUSH 1 TIME FOR START CONTINUOUSLY; 1 TIME FOR STOP IT; 1TIME TO HAVE IT IN CICLE,
•
17= GTO =IT MAKE POSSIBLE TO MOVE THE FEEDER TO A CHOICED VALUE
•
18= OPEN FEEDER VICE
•
19= CLOSE FEEDER VICE
•
20= MOVE FEEDER TO THE RIGHT
•
21= MOVE FEEDER TO THE LEFT
•
22= OPEN MACHINE VICE
•
23= CLOSE MACHINE VICE
•
24= SAW BLADE UP
•
25= SAW FRAME DOWN
•
26= not used
•
27= -V blade = DECREASES BLADE SPEED ( OR SELECT THE LOWEST , ON 2 SPEED MACHINE)
•
28= +V blade =INCREASE BLADE SPEED ( OR SELECT THE HIGHER, ON 2 SPEED MACHINE)
•
29= from 1 to 9 = NUMERIC VALUES ( +/- =CHANGE NEGATIVE/POSITIVE; DELETE VALUE)
•
30= HELP = INFORMATIONS ABOUT SELECTED OPTION
•
31=ENTER =ACCEPT DATA
•
32= EXIT =CANCEL DATA
•
33= Set -high = SETTING OF START CUT POSITION
•
34= Shift =TOGETHER WITH SOME OTHER BUTTONS GIVES AN OTHER FUNCTION ( i. e.: keeply pushed )
•
Shift and Set and Set (yes, two times ) = SETTING OF END CUT POSITION
•
Shift and -V blade and -V blade (yes, two times ) = SETTING OF LOWER STROKE POSITION
•
Shift and +V blade and +V blade (yes, two times )= SETTING OF HIGHER STROKE POSITION
•
35 , 36 = not used