IMET Spa VELOX 350 AF-NC, User Instructions

Page: 30 / 73

TRADUCTION OF THE ORIGINAL USER’S INSTRUCTIONS
VELOX 350AF-NC ED.2011eng rev.00 13/73
In the example, stars have been cleared from lines 3 &
4, so if you run this program now, only jobs 3 & 4 will run
Total Job Information
At the screen above and on the right, you can also see
useful information about your job.
You can see that there are four lines of various lenghts
and quantites.
The line across the botton tell you:
Len:-The total length of material to be run on this
program is 41,77”.
-The total quantities to be run is 12, an since you can
see that since all lines have the stars, that 12 pieces
have been run.
Changing Jobs in Progress
-Push F4 (stop)
-Push PGM
-Change the parameter you wish (length, quantity, blade
speed, etc...)
-Push ENTER
-Push F6 (OK)
-Push RUN
-Push (I) (start)
-FACE CUT: yes (with ENTER) or NO
Stopping / Suspension
The recommended way to stop a job is to push F4
(stop). This completes the cut and interrupts the job.
You may also push the STOP button
(O).
This is nearly the same as Emergency stop; the cut is
not completed.
With pushbuttons F1 and F2 it is possible to pause/to
restart the cycle, making possible some measurements
or machine regulations, even with feeder cover opened.
Cutting a Single Length (one piece)
To interrupt automatic cycling to cut 1 single semi-
automatic length.
-Push F4 the machine will stop after the next cut. You
get message: End of Prog
-Push F6 (ok)
-Open saw vice with Unclamp button
-Enter length desired on keypad
-Push
(I)
(start)
-Feeder vice will automatically move, clamp your
material, advance to the correct length, and clamp.
-Push
(I)
again
The machine will make one cut. You may now
resume previous job by pushing PGM, RUN, etc....
Changing Blade Thickness
From time to time you will want to change the thickness
of the blade you are using, i. e. for little correction on
piece lenghts. In this case you increase value if the
piece is too long, decrease it if the piece is shorter.
The machine will automatically compensate for this if you
program the correct parameter.
To proceed:
-Push F1 (set)
-Push F3 (key)
-Push F2 (folder)
-Enter the password (1-2-3-4-5-6) ENTER
-Push F6 (more)
-Push F6 (more)
-Push F6 (more)
-Push F6 (more)
-Push F6 (more) (yes, it is necessary to do this 5 times)
-Push F1 ( MD autom cicle)
You will see automatic parameters displayed
-Choose # 3, and enter your new thickness, and ENTER
-Push F6 (ok)
-Exit
-Exit
-Exit.
Start the machine, cut some pieces and check their
lenght. Use it especially in case of multiple steep feeder
repetition.
Error Messages
Can be cancelled by pushing EXIT or F6
Language changing
To change language operate as follows: starting from the
first page push the buttons: F1 , F3 , F6 , HELP ( keep it
pressed to show the present available language), digit
the choice, for ex. 1 , push F6 , F6 , F6 (to come back
on the first page. Switch off and switch on again
operating on the main switch –2/RI0346-.