IMET Spa VELOX 350 AF-NC, User Instructions

Page: 26 / 73

TRADUCTION OF THE ORIGINAL USER’S INSTRUCTIONS
VELOX 350AF-NC ED.2011eng rev.00 9/73
Setting Material Height:
-Push Raise button until sawframe is at desired height
for material to be cut (about 10 mm over it)
-Push & hold memorize upper button. You will see the
arrow adjacent to it jump to the same position as the
same position as the sawblade.
Setting Blade Depth (cutoff point):
-Push lower button until sawframe is at desired cutoff
point.
-Push & hold memorize lower button. . this functions is
by pushing SHIFT together Raise button You will see
the arrow adjacent ti it jump to the same position as the
sawblade.
Setting Blade Speed
The standard model is equipped with one speed
motor that gives best performance for aluminium
parts, using a TCT teeth blade. You have to push +2
only .
In case the machine has a special OPTIONAL feature
with 2 speed motor you can select between:
3600 + 1800 RPM for aluminium parts, using 2 different
blades (with or without TCT teeth)
2800 + 1400 RPM for thin copper parts, using TCD
teeth blades
2000 + 1000 RPM for thin brass parts, using HSS saw
blades
-+V blade= for low motor speed –
+ V blade for fast motor speed –
Coolant Controls / Chip suction plant controls
By the pneumatic air nozzle device your machine has
been factory preset that the coolant will automatically
come on during a sawing cycle, and automatically shut
off at the end of a cycle. Therefore you only need to
adjust coolant flow with adjustable valve on blade guard.
So, the button iconing coolant flow is used to control the
suction plant –OPTIONAL- if required and connected as
the electric schematic shows.
It is possible to shut off = OFF
/ to start continuously =ON
/to run in cicle as the blade motor does.
NOTE: we suggest you to use
- the continuous cycle for suction plant if the cicling
time is lower than 15 seconds,
- the interrupted cycle (start/stop with blade motor)
in any other condition
The push buttons for cycle start
( I )
and cycle
stop
( O )
are used to start and stop the sawing
cycle.
The factory preset for sawing cycle is for the sawframe
to begin the cut at the top SET point, complete the cut
and return to the same top SET point.
It is possible to change this parameter ; see section on
Adjustable Parameters.
We recommend that you make one complete sawing
cycle to test that all of your conditions are corret,
before actually making the first cut.
Fully Automatic Operation are allowed only after the
Feeder vice calibration is done.