Imagine Selenio X50, Installation And Operation Manual, Page: 80 / 136

Chapter 4
Advanced Audio Processing
66
Installing the X50OPT-ADVAUD Audio Submodule
To use the Advanced Audio Processing features, the X50OPT-ADVAUD audio submodule
must first be installed.
See page 108 for details.
Enabling DTS Neural and Dolby Modes
Follow these steps to enable the DTS Neural and Dolby Modes:
1 Navigate to Audio > Advanced Audio Processing > AAP 1 or AAP 2 Configuration >
General menu.
1 Set the Processing Mode to one of the advanced audio modes shown in Table 4-1 .
2 Configure the routing in the Audio > Routing > AAP Input Select and Audio > Routing
menus.
Note: You must select the AAP mode first ( M1 , M2 , M3 , etc.) before configuring the
routing; the AAP mode you select may change the routing settings
2 In the drop down box at the top of the column, change your selection from General to the
mode you selected in step 3.
3 Wait several seconds for the fields to refresh.
4 Configure the parameters that are available in your mode (parameters that are not applicable
are grayed out).
Once you have selected your DTS Neural modes, the Selection Status parameter
( AAP x > General ) displays one of the following:

Good

Not Enough License Credit
5 From the main section of the Advanced Audio Processing (AAP) block, (select AAP x Input
Routing and then select your audio sources.
6 In the Audio Output Routing block, select the destinations for your audio.
M17: Loudness C Dolby Digital Encode 5.1 125.43 ms 1 DDE, 3 DTS
M18: Loudness C Dolby E Encode 5.1+2.0 3.13 frames 1 DEE, 4 DTS
M19: Loudness C Dolby E Encode 4x2.0 3.13 frames 1 DEE, 4 DTS
M20: DD MultiMerge (low/high latency) 82.58 ms (low) / 103.91 ms (high) 1 DDD, 4 DTS
M21: DE MultiMerge (low/high latency) 2 16 ms (low) / 2
37.33 ms (high) 1 DED, 4 DTS
M22: DE/DD MultiMerge (low/high latency) 2 16 ms (low) / 2
37.33 ms (high) 1 DDD, 1 DED, 4
DTS
Table 4-1 Advanced Audio Processing Modes, Latency, and Credit Cost (Continued)
Mode Latency Credit Cost