Chapter 3
Controls
48
Alternately, set the
SDI Routing Mode
to
Linked
.
This action allows only one output standard on the two SDI outputs:
SDI 2
will mirror
SDI 1
.
A larger selection of options is now available in the
Analog/HDMI Out Select
parameter.
Figure 3-19.
Analog/HDMI Out Select Options
3
For composite analog output, select
525
or
625
; for HDMI, select any SD- or HD-SDI output.
Auto Route
Feature
When you set
Input Video Select
to
Auto,
the X50 automatically routes an alternate
video source if the
Primary Input
selection fails. The option you select in
Backup Input 1
is
the first alternate video source; if that source fails, the next priority is given to the selected
source in
Backup Input 2
.
The
Auto
Switch Delay
parameter makes it possible for you to set the amount of delay
before the X50 switches to the next backup input. The adjustable range is between 0 and 5
seconds.
If the Primary Input signal returns when the X50 is routed to Backup Inputs 1 or 2, the X50
reverts to the Primary Input signal.
If the
Auto Route Black
parameter is set to
Yes
, the X50 also routes alternate inputs if
black video is detected within the active picture region. The current black video detection
status is monitored at
Video > Status
.
Note
:
Certain video/audio inputs and outputs can be disabled by the power-saving controls
under
System Setup > Green (Power Save)
. If a selection or a control related to an
interface is missing, check its power save status.
Summary of Contents for Selenio X50
