Chapter 2
Installation
14
2
Verify the network settings were accepted by following the ipconfig procedure, as described
below:
a
Click
Start
, point to
Programs
>
Accessories
and then click
Command Prompt
to
open the
Command Prompt
window on the PC.
b
Type the following at the MS-DOS command prompt, and then press ENTER:
ipconfig
The
IP Address
,
Subnet Mask
, and
Default Gateway
of the PC appear. (In some
situations, the
Default Gateway
value is not shown. See Figure 2-9).
Figure 2-7
IP Address, Subnet Mask and Default Gateway of PC.
c
Write down the
IP Address
,
Subnet Mask
, and
Default Gateway
numbers of your
PC.
d
Compare the network numbers of the X50 with the numbers found in step 2c.
In general, the two
Subnet Mask
and
Default Gateway
numbers should be identical. The
first three octets of the two
IP Addresses
also are generally identical. For example, if the
X50 has an
IP Address
of 192.168.248.50, the PC could have an
IP Address
of
192.168.248.181.
3
If the network settings match, click
Close
.
Note:
Where more than one network is involved and the Point-to-Point option has been
selected (see CCS Navigator online help), the network address values may be entirely
different.
Summary of Contents for Selenio X50
