Imagine Selenio X50, Installation And Operation Manual, Page: 56 / 136

Chapter 3
Controls
42
To pass a data type that is more than one packet per frame, set Data Pass to one of the
following selections:

Pass Packets (Exact)
This selection is only available when input and output standard are same; data on
certain lines of the input video will be copied to the same line of the output video

Pass Packets (Same Line)
Data packets will be inserted into the same line as configured by Data Embed Line ; if
the line is not long enough for the amount of data, extra data will be inserted into the
following line

Pass Packets (Incremental)
Data packets will be inserted one per line into continuous lines starting from the line as
configured by
Data Embed Line
To pass data from an interlaced video standard to a progressive video standard, data must
be present on each field of the interlaced video standard. To pass data from a progressive
standard to an interlaced standard, ensure the frame rate combination allows data to be
embedded into each field of the interlaced standard.
The default value for DID/SDID is ARIB data. When generic data passing is configured to
pass ARIB data, the current audio mode is reported, and the output current audio mode is
configurable.
VPID (Video Payload Identifier) Enable
When you set VPID Enable to No , the packet descriptor from the input will be stripped
out, and not passed to the output.
This feature is not available in SD 525 and 625 formats.
Green-Power Save
You can reduce power consumption on the module by shutting down the following specific
circuits:

Video decoder

Video encoder

HDMI

DARS

SRC (AES/Analog)

AES Outputs

Audio Codec

GPI

RS-422
Select System Setup > Green (Power Save) > Yes to turn off one of the interfaces, or No
to leave it on.