Mobile DVR - Installation Manual
14/47
3.1.7 Audio Input and Output
Connect Audio out device to Audio Output connector and connect Audio input device to Audio Input connector.
It is the user’s responsibility to determine if local laws and regulations permit recording audio.
CAUTION
Input voltage of audio input device is line level and it should not be an audio input through the microphone.
Use of audio output device with an amplifier is recommended.
3.1.8 Power Input (Using as normal DVR)
Connect to main power cord of the system. The user must use the adaptor that has been given by installer.
Before plugging-in the power cord to the system, check if the power is in accordance with the system specification (Single
Phase AC 100~240V)
CAUTION
The DVR can support a 120 GB or above HDD IF, AND ONLY IF you use 18V, 2.5 Ampere adaptor. If you use 12V, 3
Ampere adaptor, the DVR may not detect the HDD. See below table for more information.
HDD
Capacity
DC Adaptor
Under 120GB
Under 200GB
Under 400GB
12V (3A)
Supported
-
-
18V (2.5A)
Supported
Supported
-
24V (1.5A)
Supported
Supported
Supported
3.1.9 Power Input (Using as mobile DVR)
Connect the power wire to vehicle power. The power has to be between DC 12V to DC 30V. Please connect the wire to vehicle power in
order to use the DVR.
One is 12V ~ 30V. And another one is for ground. Check the cable before plugging.
CAUTION
To connect the power, you will need 5566 Wafer from Molex (Model Number: 5015TW-2S-W). Please contact installer for
more information.
For normal use: Connect supplied adaptor.
For mobile use: Connect power wire to the connector. Left slot is for + (PWR) and right slot is for –
(GROUND).